Ricoh Beluga-C1 Training page 109

HDD Encryption Unit
After Replacing the HDD or NVRAM
If the HDD (hard disk drive) must be replaced, a
new encryption key must be stored.
This procedure is for the user to do. It is not in
the service manual. We studies this on the
previous slide.
It is theoretically possible to copy the existing
encryption key from the controller board, but
there is no information about how to do this.
If the NVRAM is defective, then the HDD
encryption unit cannot be recovered, even if the
controller is OK.
The user must obtain a new HDD encryption
unit.
Slide 109
The operation manual explains how to make a new encryption key, as explained
on the previous slide.
109
Beluga-C1/C1.5 Training