Ricoh Beluga-C1 Training page 165

LPH Replacement and Adjustment
Install the new LPH
Note the SP settings on the decals (see below)
Slide 165
SP settings on the decals
This decal is only on the spare parts, not on the original part installed at the
factory. See the factory setting sheet for the original factory settings.
Before re-installing the right copy tray, read the LPH settings from the labels
attached to the LPH.
Look for 4 labels, probably on the underside of the unit. See the manual for
an example
Input these into the correct SP modes, as explained in the manual.
In the factory, the settings for the installed LPH unit are already made.
However, if you do an NV-RAM reset, you may have to re-input these
values.
What are these settings?
The LPH consists of three heads joined together.
SP 2952 001 informs the machine where the left and central heads are joined
(I.e., at which pixel).
SP 2952 002 informs the machine where the central and right heads are joined.
Now please go to the next slide for an explanation other two SP settings.
165
Beluga-C1/C1.5 Training