Preparing The Toner Cartridge - Ricoh Beluga-C1 Training

Preparing the Toner Cartridge

Hold this
Joint
Slide 54
Install the toner cartridge before you input lot numbers and initialize developer.
You must shake the toner cartridge to make the toner loose inside the cartridge.
If not, torque in the mechanism is too high and the development unit is damaged.
In case you forget, a slip clutch was added to the mechanism between the toner
hopper and the toner supply clutch to prevent this damage.
Shake the cartridge
several times and make
sure that the toner is
moving inside.
Push the cartridge cap. At
the same time, tap the
bottom of the toner
cartridge 4 or 5 times.
Hold the cartridge
horizontally and shake it
quickly from side to side
4 or 5 times.
Hold the joint of the toner
cartridge with two
fingers, and turn the joint.
If the joint does not turn,
Push this
do the procedure again.
Cap
54
Beluga-C1/C1.5 Training