Scan Separate Job Parts - Oce VarioPrint 2045-65 NC Job Manual

Scan separate job parts

Introduction
You must create different job parts if the set of originals has more than one
original type (see 'Prepare the scan job' on page 141).
To start a scan job with separate job parts, proceed as follows:
Prepare the first job part.
■
Enter the settings for the digital document.
■
Enter the settings for the first job part.
■
Press the combine key .
■
Prepare the next job part.
■
Enter the settings for the next job part.
■
Press the combine key .
■
Press the start key .
■
Before you begin
Inspect the originals and make separate job parts (see 'Prepare the scan job'
■
on page 141).
Scanning separate job parts
Collect the job parts.
1
Place the originals of the first job part face down in the automatic document
2
feeder or on the platen.
Follow the feed direction according to the dimensions and orientation of the
information of the job part (see 'Prepare the scan job' on page 141).
Select the 'Scan' mode
3
The 'Workflow' section automatically opens.
Select a 'Scan profile' using the arrow keys
4
on page 138).
5
Enter the settings for the digital document.
Activate the 'Digital document' section.
■
Make sure that the 'Page size' card is open.
Select the page size and the orientation in the 'Size' function box.
■
The scan function
.
(see 'About the scan profiles'
155