Copy Separate Job Parts - Oce VarioPrint 2045-65 NC Job Manual

Copy separate job parts

Introduction
You must sort the set of originals to make separate job parts if the set of
originals has more than one original type (see 'Prepare the copy job' on
page 98).
To start a copy job with separate job parts, proceed as follows:
Prepare the first job part.
■
Enter the settings for the required copy.
■
Enter the settings for the first job part.
■
Press the combine key .
■
Prepare the next job part.
■
Enter the settings for the next job part.
■
Press the combine key .
■
Press the start key .
■
Before you begin
Inspect the originals and make separate job parts (see 'Prepare the copy
■
job' on page 98).
Copying separate job parts
Collect the job parts.
1
Place the originals of the first job part face down in the automatic document
2
feeder or on the platen.
Follow the feed direction according to the dimensions and orientation of the
information on the originals of the job part.
Select the 'Copy' mode
3
The 'Basic' section automatically opens.
Enter the settings for the required copy.
4
Select '1-sided' or '2-sided' in the 'Copy' function box of the 'Basic' section.
■
Select 'Yes' or 'No' in the 'Staple' function box.
■
Activate the 'Extra' section.
■
Open the 'Copy type' card.
Keep the setting or change the copy type.
Select the number of copies.
■
The copy function
.
117