Prepare The Scan Job - Oce VarioPrint 2045-65 NC Job Manual

Prepare the scan job

Introduction
When preparing a scan job, first inspect your originals. If the originals are
different sizes and types, sort the set of originals into separate job parts. Each
job part requires a different setting profile. The combine key
create one assembled scan job from the separate job parts.
The Océ VarioPrint 2045-65 NC has two input locations for your originals, the
automatic document feeder and the platen.
Standard originals
A standard original represents:
A standard size (11 x 17, 8.5 x 11 or 5 x 8)
A standard weight (30 -80 lb. bond)
Non-standard originals
A non-standard original represents:
A page of a book
A curled or damaged original
A non-standard size (not 11 x 17, 8.5 x 11 or 5 x 8)
A non-standard weight (less than 30 lb. bond or more than 80 lb. bond)
Job parts
If the set of originals has more than one original type, make separate job parts.
Then, enter the settings for each job part.
Split the set of originals in separate job parts if the set of originals con-
tains:
One or more non-standard originals
More than 50 8.5 x 11, 50 5 x 8 or 35 11 x 17 originals
The scan function
allows you to
141