Oce VarioPrint 2045-65 NC Job Manual page 152

[19] The page size card
Function
'Selection'
'Size'
'Enlarge-
ment or re-
duction'
[19] The page size card
You can enter the key operator mode if you open the 'Special settings'
Note:
card in the 'Digital document' section. The key operator mode is protected and
requires a password entry
150 Océ VarioPrint 2045-65 NC Job Manual
Description of the function
The 'Automatic' value is the default setting in the 'Selection'
function box.
The value changes to 'Manual' if you select a different size.
The selected 'Size' for the digital document matches the infor-
mation scanned by the automatic document feeder.
Because the default size setting does not change, the platen
does not detect the dimensions of the originals.
Make sure that the orientation of the selected page size match-
es the feed direction of the originals (see 'Prepare the scan job'
on page 141).
The 'Automatic' value is the default setting in the 'Enlargement
or reduction' function box.
The Océ VarioPrint 2045-65 NC calculates the ratio, according
to your settings, if you use the automatic document feeder.
Manually adjust the 'Enlargement or reduction' if you need an
enlarged or reduced digital document with the platen (see
'Make an enlarged or reduced digital document' on page 157).