Oce VarioPrint 2045-65 NC Job Manual page 126

Copying on special material inserted in the special feeder
Place and align the original face down in the automatic document feeder .
1
Follow the feed direction according to the dimensions and orientation of the
information on the original.
Insert the special material in the special feeder.
2
The face-down side is copied.
Select the 'Copy' mode
3
The 'Basic' section automatically opens.
Activate the 'Paper' section.
4
Make sure that the 'Paper input' card is open.
Select 'Special feeder' .
5
Select the required size and orientation of the inserted material in the 'Size'
6
function box.
The upper icon provides non-standard sizes to select.
The enlargement or reduction is automatically adjusted and is displayed in the
'Basic' section.
[80] Select the special feeder and the size of the required material
[80] Select the special feeder and the size of the required material
Activate the 'Basic' section.
7
Select '1-sided' or '2-sided' in the 'Original' function box.
8
To copy 2-sided on the special material, feed the sheet into the special feeder
a second time.
The 'Staple' and 'Copy' functions are locked.
Note:
Select the number of copies.
9
Press the start key .
10
Close the special feeder.
11
You can use the platen to copy the originals on the special material.
Note:
Remember that the enlargement or reduction is not adjusted automatically (see
'Make an enlarged or reduced copy' on page 119).
124 Océ VarioPrint 2045-65 NC Job Manual
.