Prime Solvent Flush Pump - Graco XM Series Operation

Prime

Prime Solvent Flush Pump

1. Connect flush pail ground wire to a metal pail of
solvent.
2. Place siphon tube in the pail of solvent.
3. Open solvent flush valve (AK) on mix manifold.
4. Ensure trigger lock is engaged. Remove spray tip.
TI1949a
30
5. Disengage trigger lock and trigger gun into a
grounded pail. Use a pail lid with a hole to dispense
through. Seal around hole and gun with a rag to
prevent splash back. Be careful to keep fingers
away from front of gun.
6. Open solvent pump air valve (CB). Pull out and
slowly turn solvent pump air regulator (CG)
clockwise to prime solvent pump and push air out of
mix hose and gun. Trigger gun until all air is purged.
CB
AK
7. Close solvent pump air valve (CB) and trigger gun
to relieve pressure. Engage gun trigger lock.
TI1948a
TI1950a
TI1949a
TI1953a
CG
312359M