Setup; Connect Power Cord - Graco XM Series Operation

Setup

Setup

Connect Power Cord

(For sprayers with heater junction boxes. Non-hazardous
location sprayers only.)
Graco does not supply heater junction box power cords.
Use the following chart to determine which power cord
your specific model requires.
Power Cord Requirements
Voltage Cord Specification AWG (mm
240V, 1 PH 4 (21.2) 2 wire + ground
240V, 3 PH 6 (13.3) 3 wire + ground
380V, 3 PH 6 (13.3) 4 wire + ground
Sprayers without heaters for non-hazardous locations
include a U.S. style NEMA 5-15 power cord and an
IEC-320 power cord. (European and Australian
adapters are also included.) These power cords are
rated for 90-240 Vac, 47-63 Hz. See the XM
Plural-Component Sprayers Repair-Parts manual or the
XM Plural-Component OEM Sprayers Instructions-Parts
manual for part numbers.
Disregard terminal numbers on disconnect switch
blocks. Wire to positions shown.
1. Open junction box cover.
2. Connect electrical cord as follows.
20
230V, 1 Phase: Use a screwdriver to connect two power
leads to the top terminals N and L2 positions. Connect
green to ground (GND).
N
230V, 3 Phase Delta: Use a screwdriver to connect
three power leads to top terminals L1, L2, and L3.
2
)
Connect green to ground (GND).
N
380V, 3 Phase WYE: Use a screwdriver to connect three
power leads to the top terminals L1, L2, and L3. Connect
neutral to N. Connect green to ground (GND).
N
7L4
L1 L2 L3
1L1
ti8611a
L1 L2 L3
1L1
ti8612a
7L4
L1 L2 L3
1L1
ti8613a
PE
L1 L2
N 1 2 3
GRND
G
N L1 L2 L3
PE
L1 L2 L3
N 1 2 3
GRND
G
N L1 L2 L3
PE
N L1 L2 L3
N 1 2 3
GRND
G
N L1 L2 L3
312359M