100 Mbps/1 Gbps/10 Gbps Rj-45 Port Led State Indicators - Avaya VSP 7200 Series Installing Manual

Installing the Avaya Virtual Services Platform 7200 Series
Label Color and Status
Green (steady)
Green (blinking)
Status Off
Amber (steady)
Amber (blinking)
Green (steady)
Green (blinking)
RPS Off
Amber (steady)
Amber (blinking)
Green (steady)
Fan Amber (steady)
Amber (blinking)
Green (steady)

100 Mbps/1 Gbps/10 Gbps RJ-45 port LED state indicators

This section describes the RJ-45 copper port LED state indicators by color and fluctuation cues. The
up arrow on the left indicates the top port; the down arrow on the right indicates the bottom port.
Table 12: 100 Mbps/1 Gbps/10 Gbps port LED state indicators
Label Color and Status
Link/Act Off
Amber (steady)
Amber (blinking)
Green (steady)
Green (blinking)
Green (slow blinking)
Blue (steady)
Blue (blinking)
November 2016
Description
The switch is receiving power from either one of the power
supplies (if two power supplies are installed).
The switch is resetting.
The switch is non-operational.
The switch encountered an error when running the diagnostic
software.
The switch is booting and running diagnostic software. This is
normal activity during the boot process.
The switch loaded the agent software code and is operating
normally.
The switch is loading the agent software code.
A second power supply is not present in either PSU1 or PSU2.
The second power supply, which was operating in either PSU1
or PSU2, was removed from the chassis.
The second power supply in either PSU1 or PSU2 is present,
but not supplying power to the switch.
The second power supply (in either PSU1 or PSU2) is present
and operating normally as a redundant power supply (RPS).
A fan module has been removed.
A fan module has failed.
All fan modules are operating normally.
Description
There is no transceiver present and the port is administratively
enabled.
The port has a link in 100 Mbps mode.
The port has a link and data activity in 100 Mbps mode.
The port has a link in 1 Gbps mode.
The port has a link and data activity in 1 Gbps mode.
The port is administratively disabled.
The port has a link in 10 Gbps mode.
The port has a link and data activity in 10 Gbps mode.
Installing the Avaya VSP 7200 Series
Comments on this document? infodev@avaya.com
36