Avaya VSP 7200 Series Installing Manual page 67

e. Close the retaining latch so that it wraps around the frame and locks into place.
f. Repeat the above steps on the rear bracket.
10. Repeat these steps for the rack rail on the other side of the frame.
11. Use the following steps to install the switch in the equipment rack to complete the
installation:
a. Insert the chassis rails on the switch into the rack rails on the frame.
November 2016 Installing the Avaya VSP 7200 Series
Comments on this document? infodev@avaya.com
Installing the switch in an equipment rack
67