Avaya VSP 7200 Series Installing Manual page 28

Installing the Avaya Virtual Services Platform 7200 Series
Procedure
1. If there is a power supply cover, remove it and save for possible future use. To remove the
cover, push the tab on the spring latch to the left and pull on the extraction handle.
Important:
If you only have one power supply installed, the other slot must be covered to ensure
proper ventilation. If a power supply fails, replace it as soon as you can but leave it in
place until you do. Leaving a power supply slot unpopulated impairs the ability of the
fans to cool the chassis.
2. Slide the power supply into the slot.
3. Verify that the power supply is fully seated in the slot. The spring latch should engage and
return to its original position.
November 2016 Installing the Avaya VSP 7200 Series
Comments on this document? infodev@avaya.com
28