Avaya VSP 7200 Series Installing Manual page 29

Note:
The chassis design prevents an incorrect installation of a power supply. If you insert a
power supply upside down, it will not fully insert.
Important:
The VSP 7200 Series does not have a power switch. When you connect the DC power
source to the DC power supply wiring assembly and then plug the DC power supply
wiring assembly into the DC power supply, the switch powers up immediately.
Warning:
Disconnecting the DC power supply wiring assembly from the power supply is the only
way to turn off DC power to the VSP 7200 Series. Allow at least 30 seconds for the VSP
7200 Series to fully power down before restoring power. Otherwise, the VSP 7200
Series might produce a core file during the reset leading to an extra delay during boot
time.
4. Once you install a power supply, use the following steps to connect the DC power supply
wiring assembly:
a. Avaya supplies a DC power supply wiring assembly to connect the DC power supply to
the DC input power source.
b. Refer to the tag attached to the DC power supply wiring assembly to insert the cables
into their appropriate connectors.
Voltage:
Ensure that the positive and negative power inputs are connected to the correct
connectors and that the switch is properly grounded before connecting it to a power
source.
November 2016 Installing the Avaya VSP 7200 Series
Comments on this document? infodev@avaya.com
Installing a power supply
29