Management Port Led State Indicators - Avaya 8000 Series Installing Manual

Label Color and Status
Amber (blinking)
Green (steady)
Green (blinking)
RPS Off
Amber (steady)
Amber (blinking)
Green (steady)
Fan Amber (steady)
Amber (blinking)
Green (steady)

Management port LED state indicators

This section describes the management port LED state indicators by color and fluctuation cues. The
management port uses two bi-colored LEDs to indicate the activity and speed of the link.
• The LED on the left side of the port (Speed) indicates the current speed of the port.
• The LED on the right side of the port (Link/Act) indicates the status of the link and whether or
not it's active.
Table 15: Management port LED state indicators
Label Color and Status
Speed Off
Amber (steady)
Green (steady)
Link/Act Off
Amber (steady)
Amber (blinking)
Green (steady)
Green (blinking)
November 2016
Description
The switch is booting and running diagnostic software. This is
normal activity during the boot process.
The switch loaded the agent software code and is operating
normally.
The switch is loading the agent software code.
A second power supply is not present in either PSU1 or PSU2.
The second power supply in PSU1 or PSU2 is removed.
The second power supply, which was operating in PSU1 or
PSU2, is either a fault condition or a PSU is present but not
supplying power.
The second power supply (in either PSU1 or PSU2) is present
and operating normally as a redundant power supply (RPS).
A fan module has been removed.
A fan module has failed.
All fan modules are operating normally.
Description
The port is operating at 10 Mbps.
The port is operating at 100 Mbps.
The port is operating at 1 Gbps.
N/A
The port admin is disabled.
The port is not in use.
The port has no data activity.
The port has data activity.
Installing the Avaya VSP 8000 Series
Comments on this document? infodev@avaya.com
LED state definitions
83