Figure 35. SAS cable
3. Plug the replacement cable into the specific port.
4. Ensure that the SAS cable is fully inserted. A click is heard when the cable is successfully inserted.
Replacing a control enclosure chassis
4
This topic describes how to replace a control enclosure chassis.
4
4
Note: Ensure that you know the type of enclosure chassis that you are replacing. The procedures for
replacing a control enclosure chassis are different from those procedures for replacing an expansion
4
enclosure chassis. For additional information, see "Replacing an expansion enclosure chassis" on page
4
4
107.
104
Storwize V7000 Version 6.1.0: Troubleshooting, Recovery, and Maintenance Guide