Installing The Service Access Cover On A Stand-Alone 8286-41A System - IBM Power System 8247-42L Manual
System backplane
Hide thumbs
Also See for Power System 8247-42L:
- Manual (72 pages) ,
- Installing (54 pages) ,
- Manual (42 pages)
Table of Contents
Advertisement
Figure 127. Installing the service access cover
Installing the service access cover on a stand-alone 8286-41A system
Use this procedure to install the service access cover on a stand-alone 8286-41A system.
To install the service access cover on a stand-alone system, complete the following steps:
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Slide the cover (B) on to the system unit.
3. Close the latch release (A) by pushing it in the direction shown.
143
Common procedures for removing and replacing the system backplane
Hide quick links:
Advertisement
Table of Contents
