IBM Power System 8247-42L Manual page 22

c. Record System Power Control settings:
1) In the navigation area, select Power Restart/Control > Power On/Off settings.
2) Manually record the values of system diagnostic level for the next boot, firmware boot side
for the next boot, system operating mode, server firmware start policy, system power off
policy, and default partition environment.
d. Record System Service Aids settings:
1) In the navigation area, select System Service Aids > System Dump.
2) Manually record the system dump policy, hardware content, and server firmware content
settings.
3) In the navigation area, select System Service Aids > Service Processor Dump.
4) Manually record the service processor dump setting.
e. Record System Configuration settings:
1) In the navigation area, select System Configuration settings > System Name.
2) Manually record the system name.
f. Record Network Services settings:
1) In the navigation area, select Network Services settings > Network Configuration.
2) Manually record the service processor and IP version.
3) In the navigation area, select Network Services settings > Network Access.
4) Manually record the allowed and denied IP addresses.
g. Record Login Profile settings:
1) In the navigation area, select Login Profile > Update Installed Languages.
2) Manually record the currently installed languages.
h. Record Vital Product Data information:
1) In the navigation area, select System Configuration > Program Vital Product Data > System
Brand.
2) Manually record the value for the system brand, which appears in the right pane.
3) In the navigation area, select System Configuration > Program Vital Product Data > System
Keywords.
4) Manually record the machine type-model, system serial number, system unique ID values,
reserved, and RB keyword0.
5) In the navigation area, select System Configuration > Program Vital Product Data > System
Enclosures.
i. Record Enclosure information:
1) In the right pane, select the Enclosure location: UXXXX.YYY.ZZZZ and click Continue.
2) Manually record the values of enclosure location, feature code/sequence number, enclosure
serial number, and reserved.
j. Record any service processor settings that you might have set by using the operating system
commands.
11. For a rack-mounted system, place the system into the operating position. For instructions, see
"Placing the rack-mounted system into the operating position" on page 150.
12. Disconnect the power source from the system by unplugging the system. For instructions, see
"Disconnecting the power cords from the system" on page 154.
Note: The system might be equipped with redundant power supply. Before you continue with this
procedure, ensure that all power to your system is disconnected.
(L003)
4
System backplane