Installing The Front Cover And Front Door On A Stand-Alone 8286-41A System - IBM Power System 8247-42L Manual

A
B
Figure 118. Installing the front cover

Installing the front cover and front door on a stand-alone 8286-41A system

Use this procedure to install the front cover and front door on a stand-alone 8286-41A system to access
components or perform service.
To install the front cover and front door, complete the following steps.
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Align the cover until the two cover tabs (A) are seated into the slots on the base plate (B), as shown
in the following figure.
136
System backplane