IBM Power System 8247-42L Manual page 72

c. If not already connected, connect all system power cables by plugging them into power outlets.
Note: Do not start the system now.
Can you access the service network?
v Yes: Go to step 16 on page 53.
v No: Go to the next step.
20. Reset the service processor.
If you are still not able to access the service network, reset the service processor by pressing the
pinhole switch (G) on the control panel. See Figure 57.
Figure 57. Pinhole switch that is on the control panel
21. Go to step 12 on page 52.
22. Change the admin user ID password.
Change the password of the admin user ID when prompted by completing the following steps:
a. In the navigation area of the ASMI, expand Login Profile.
b. Select Change Password under Login Profile.
c. Specify the required information, and click Continue.
As a security measure, you must enter your current user password in the Current password for
current user ID field.
54
System backplane
A B
Front View
Top View
F
H
C D E
I J
G