IBM Power System 8247-42L Manual page 126

b. Select System Name under System Configuration.
c. Enter the wanted system name.
d. Click Save settings to update the system name to the new value.
The new system name is displayed in the status frame, the area where the Log out button is located.
If another method, such as the management console, is used to change the system name, the status
frame does not reflect the change.
25. Set the time-of-day.
To set the time-of-day, complete the following steps:
a. In the navigation area of the ASMI, expand System Configuration.
b. Select Time of Day under System Configuration.
c. If the system is powered off, the right pane displays a form that shows the current date (month,
day, and year) and time (hours, minutes, and seconds).
d. Change the date, the time, or both, and click Save settings.
26. Verify the server firmware level.
Verify that the server firmware level is the same as the level recorded before you replace the system
backplane. If the level is different, the firmware might have to be reinstalled. For information about
installing firmware, see Getting firmware fixes (http://www.ibm.com/support/knowledgecenter/
POWER8/p8ha5/fix_serv_firm_kick.htm).
27. Restore service processor settings.
Reenter any of the following settings that were previously changed through the ASMI, unless you
want to use the default settings.
v System name setting
v System Power Control settings
v System Service Aids settings
v System Configuration settings
v Network Services settings
v Performance Options settings
v Login Profile settings
v Boot List settings
28. Reset service processor settings.
a. Reset any service processor settings that you might have set by using operating system
commands. You recorded these settings at the beginning of this procedure.
b. If you choose to change the HMC access password, choose one of the following tasks depending
on the interface type of the HMC:
v If you are using an HMC Classic or HMC Enhanced interface, complete the following steps:
a. In the navigation area, select Systems Management > Servers.
b. In the content area, check the box for the appropriate system.
c. From the Tasks menu, select Operations > Change Password.
d. Enter the required information and click OK.
v If you are using an HMC Enhanced + Tech Preview (Pre-GA) interface, complete the following
steps:
a. In the navigation area, select the managed system and click the Users and Security icon
, and then select Users and Roles.
b. In the content pane, click Change User Password.
108
System backplane