Installing The Front Cover; Installing The Front Cover On A Rack-Mounted 5148-21L, 5148-22L, 8247-21L, 8247-22L, 8284-21A, Or 8284-22A System - IBM Power System 8247-42L Manual

Note: The side cover has cover tabs that lock it into place.
Figure 116. Removing the 8286-41A side cover

Installing the front cover

Use this procedure to install the front cover on a 5148-21L, 5148-22L, 8247-21L, 8247-22L, 8247-42L,
8284-21A, 8284-22A, 8286-41A, or 8286-42A system.
Installing the front cover on a rack-mounted 5148-21L, 5148-22L, 8247-21L,
8247-22L, 8284-21A, or 8284-22A system
Use this procedure to install the front cover on a rack-mounted 5148-21L, 5148-22L, 8247-21L, 8247-22L,
8284-21A, or 8284-22A system.
To install the front cover, complete the following steps:
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Slide the cover onto the system.
3. Close the release latches by pushing in the direction shown in Figure 117 on page 135. The cover
snaps into place and has an indentation where you can hold onto it more easily.
4. Replace the shipping screws (A).
Note: Replacing the shipping screws is optional but should be done in geographic areas that are
prone to seismic activity.
134
System backplane