IBM Power System 8247-42L Manual page 127

c. From the Change User Password window, enter your current password, specify a new
password you want to use, and reenter the new password.
d. Click OK.
v If you are using the HMC command line, type:
/usr/hmcrbin/chsyspwd -m managedsystem -t access --passwd --newpasswd newpassword Where:
– The value for managedsystem is the new service processor's managed system name.
– No value for passwd is entered allowing authentication.
– The value for newpasswd is the new password value.
29. Recover partition data on the service processor.
Profile data that is stored in the managed server has been cleared or corrupted.
v If you are recovering profile data, using an HMC Classic or HMC Enhanced interface, complete
the following steps:
a. In the navigation area, select Systems Management > Servers.
b. In the content area, check the box for the appropriate system.
c. From the Tasks menu, select Configuration > Manage Partition Data > Restore.
d. From the list of backup files, select the profile information that you want to restore.
e. Select a restore option.
f. Click OK.
v If you are recovering profile data, using an HMC Enhanced + Tech Preview (Pre-GA) interface,
complete the following steps:
a. In the navigation area, click the Resources icon
b. In the content pane, select the system name that contains the partition.
c. In the navigation area, select System Actions > Legacy > Restore.
d. From the list of backup files, select the profile information that you want to restore.
e. Select a restore option.
f. Click OK.
30. Update vital product data.
If your system is running IBM i and is not managed by a management console, you must update the
load source after you replace the system backplane. To update the load source without using the
management consoles, complete the following steps:
a. Load the I_BASE_01 Licensed Internal Code optical media into the device that is defined for the
system and access it to complete an initial program load (IPL).
Note: This IPL can take several minutes.
b. After the Select a Language Group display is shown, press Enter to select the default language
feature 2924 (English).
Note: To change the language feature, type the language feature that appears on the media that
contains the operating system, and then press Enter.
Confirm the language feature by pressing Enter.
c. From the Install Licensed Internal Code display, select option 2 (Work with Dedicated Service
Tools (DST) and press Enter.
Use the Dedicated Service Tools to make sure the disk units, including the load source, are
reporting correctly. Make sure that there are no errors that might prevent the IPL from disk.
When all errors are resolved and the load source disk is reporting correctly, continue with the
next step.
, and then select All Systems.
System backplane
109