Placing The Transceiver In Mobile Relay Station Mode - Kenwood NX-5000 Series Common Function Reference

16 MULTI RF DECK/ MULTI CONTROL HEAD
16.18 Relaying the Received Signal (Mobile Relay Station)

Placing the Transceiver in Mobile Relay Station Mode

Mobile Relay Station functions if RF Deck 1 and RF Deck 2 are placed in Mobile Relay Station Mode.
Placing the RF Decks in Mobile Relay Station Mode
RF Deck 1 and RF Deck 2 can be placed in Mobile Relay Station Mode by one of the following methods:
0
Pressing the Mobile Relay Station key
0
Activating the Mobile Relay Station port
0
Receiving a PC command from the communication port to enable Mobile Relay Station Mode
The Key Beep A (1 beep) sounds from the transceiver and "MOBILE RELAY" appears on the display when Mobile Relay
Station is enabled.
Note
If the SCM is connected to the transceiver, "Initializing" appears on the display while the SCM is being initialized when
the transceiver enters Mobile Relay Station Mode.
About how to manage when a failure occurs
0
If a Mobile Relay Channel is not configured in Mobile Relay Channel List, the transceiver cannot enter Mobile Relay
Station Mode. In this case, configure a Mobile Relay Channel again. (Refer to
0
If "Ch Mismatch" appears when the transceiver enters Mobile Relay Station Mode, a problem may exist in the configuration
of a Mobile Relay Channel. In this case, check the configurations of System Type, Channel Type and Channel
Spacing for the channel configured as a Mobile Relay Channel. (Refer to
0
If "Cable Error" appears when the transceiver enters Mobile Relay Station Mode, a problem exists in the connection of
the cable.
Check the connection of the cable. (Refer to
0
Check the Mobile Relay Station DB-25 Cable configuration. (Refer to
0
Common FUNC (K, F)/Ver 2.20
Configuring Mobile Relay
Connecting the RF Deck by Using a D-sub 25-pin
Configuring Mobile Relay
Configuring Mobile Relay Station.)
Station.)
Cable.)
Station.)
CONTENTS INDEX
333