Table of Contents
Advertisement
PREPARATION FOR MOBILE AND FIXED STATION OPERATION
1
MOBILE INSTALLATION
2
3
Install the transceiver in a safe, convenient position
inside your vehicle that minimizes danger to your
4
passengers and yourself while the vehicle is in motion.
5
For example, consider installing the transceiver under
the dash in front of the passenger seat so that knees or
6
legs will not strike the radio during sudden braking of
7
your vehicle. Try to pick a well-ventilated location that is
shielded from direct sunlight.
8
9
■
Installation Example
10
Use the supplied mounting bracket to install the
11
transceiver inside your vehicle. To enjoy the best
viewing angle, you can position the transceiver in the
12
bracket in a number of ways as shown below.
13
14
15
16
17
18
19
20
21
22
2
■
Installation Steps
1 Install the mounting bracket in the vehicle using
the supplied flat washers and self-tapping screws.
There are 4 washers and 4 screws supplied.
• The bracket can be mounted with the bracket
opening for the transceiver facing down for
underdash mounting, or with the opening facing up.
• The bracket must be installed so that the 4 screw
holes on the edge of each bracket side are facing
forward.
Flat washer
Self-tapping
screw
2 Position the transceiver, then insert and tighten
the supplied hexagon SEMS screws and washers.
There are 2 screws and 2 washers supplied for
each side of the bracket.
• Double check that all hardware is tightened to
prevent vehicle vibration from loosening the bracket
or transceiver.
SEMS screw
Hide quick links:
Advertisement
Table of Contents
