Power-On Tone - Kenwood NX-5000 Series Common Function Reference

6 SOUND
6.1 Tones that Sound When a User Operates the Transceiver or When the Transceiver Status Is Changed

Power-on Tone

A Power-on Tone sounds from the transceiver when the transceiver is turned ON.
The volume level of Power-on Tone can be configured using KPG-D1/ D1N. (Refer to
Various Tones (Tone Volume).)
Function
Power-on Tone A This tone sounds from the transceiver when the transceiver is turned ON.
This tone sounds when the transceiver is turned ON by pressing and holding the Power switch
Power-on Tone B
while " Ignition & Switch" is configured in Ignition Sense Type. In this case, Timed Power-off is
(Mobile only)
not activated.
Configuring a tone which sounds when the transceiver is turned ON (Power-on Tone)
The tone pattern (frequency and length) for a Power-on Tone A which sounds from the transceiver when the transceiver is
turned ON can be configured using KPG-D1/ D1N.
The default for a Power-on Tone A is a frequency of 1480 Hz and a tone length of 500 ms. The tone length can be extended
up to 1000 ms.
Configuration using KPG-D1/ D1N
Configuring Power-on Tone (
Control Tone
A Control Tone sounds when a function is activated by a user operating the transceiver.
The volume level of Control Tone can be configured using KPG-D1/ D1N. (Refer to
Tones (Tone Volume).)
Function
Key Beep A This tone sounds from the transceiver when a function is enabled by pressing a key.
Key Beep B This tone sounds from the transceiver when a function is disabled by pressing a key.
This tone sounds from the transceiver when Home Channel or Direct Channel is changed using
Key Beep C the Home Channel Select or Direct Channel Select key, or when the time in the transceiver is
changed in Clock Adjustment Mode.
Key-entry Error Tone This tone sounds from the transceiver when the operation activated by pressing a key is denied.
This tone sounds from the transceiver when the lowest zone or channel number is selected. Also,
Rollover Tone this tone sounds if the lowest list number is selected in various list modes, or if the smallest font
or lowest value is selected while entering characters or code. (Refer to
This tone sounds from the transceiver if "End Stop" is configured in Rollover/ End Stop.
This tone sounds from the transceiver if the zone or channel number is decreased while the zone
Stop Tone
or channel having the lowest number is selected. Or, this tone sounds from the transceiver if the
zone or channel number is increased while the zone or channel having the lowest number is
selected. (Refer to
Password This tone sounds from the transceiver if the entered password matches the password
Authorization Tone preconfigured for the transceiver.
Common FUNC (K, F)/Ver 2.20
Table 6-2 Power-on Tone
Transceiver Settings > Special Tone)
Table 6-3 Control Tone
Rollover/ End Stop.)
Configuring the Volume Level of
Description
Configuring the Volume Level of Various
Description
CONTENTS
Rollover/ End Stop.)
107
INDEX