Microphone-Hook - Kenwood NX-5000 Series Common Function Reference

16 MULTI RF DECK/ MULTI CONTROL HEAD

16.12 Microphone-hook

16.12 Microphone-hook
Hook Control exists as a function to control the microphone hook status for Mobile.
Hook Control is the function to specify the conditions to place the transceiver in the on-hook state if both the Local Mic
Hook and the External Hook are used. By using this function, whether the on-hook state of the transceiver when both the
Local Mic Hook and the External Hook are used is determined by AND or by OR can be changed.
Also, in a Multi RF Deck/ Multi Control Head structure, whether the on-hook state of the transceiver of when the following
Local Mic Hook and External Hook are used together is determined by AND or by OR can be changed:
0 the Local Mic Hook of Control Head 1 or Control Head 2 for the Selected RF Deck
0
the External Hook of Control Head 1 or Control Head 2, or the External Hook of an RF Deck
The transceiver behaves as follows according to the configuration in Hook Control (AND, OR):
0
AND
The transceiver behaves as the on-hook state if both the Local Mic Hook and External Hook are in the on-hook state.
Also, the transceiver behaves as the off-hook state if either the Local Mic Hook or External Hook is in the off-hook state.
0
OR
The transceiver behaves as the on-hook state if either the Local Mic Hook or External Hook is in the on-hook state. Also,
the transceiver behaves as the off-hook state if both the Local Mic Hook and External Hook are in the off-hook state.
The Unselected RF Deck judges the hook state of the connected RF Deck only by the input from the External Hook of the
RF Deck, and performs the hook behavior.
Hook Control is applied to the following configurations:
0
Off-hook Scan
0
Off-hook Voting
0 Off-hook Site Roaming
0
Off-hook Decode
0
Off-hook Connect
0
Off-hook Speaker Revert
Configuration using KPG-D1/ D1N
Configuring Hook Control (
GPS
16.13
In a Multi RF Deck/ Multi Control Head structure, the built-in GPS receiver unit or an external GPS receiver unit can be used.
In a Multi RF Deck system, a GPS antenna is connected to RF Deck 1. The acquired GPS data is transferred from RF Deck
1 to another RF Deck. Whether to enable or disable Built-in GPS Receiver can be toggled after entering GPS Mode by
pressing the GPS key or Menu key, regardless of whether RF Deck 1 is the Selected RF Deck.
Common FUNC (K, F)/Ver 2.20
Transceiver Settings > Optional Features > Optional Features 1 > Microphone-hook)
CONTENTS INDEX
300