Removing And Installing Passenger Airbag Unit - Skoda FABIA 2000 Workshop Manual

FABIA 2000 Body Work
Note
♦
The restoring ring with slip ring must be removed and
installed when the steering wheel is in centre position
(wheel in straightahead position).
♦
Restoring ring with slip ring are secured by a clip in the
centre position when supplied as a replacement part.
Remove this clip just before installing the parts.
♦
If it is intended to re-install the restoring ring with slip
ring, fix in centre position with adhesive tape.
Caution!
Do not turn the restoring ring. There is a risk of the
restoring ring fracturing while driving.
Installing
Installation is carried out in the reverse order.
Removing and installing passenger air-
bag unit
WARNING!
Safety measures should be observed when han-
dling airbag units ⇒ 69-3 page 1.
After connecting the battery earth strap, a few ad-
ditional operations are necessary ⇒ Electrical Sys-
tem; Rep. Gr. 27.
Removing
–
Disconnect earth strap of the battery.
Remove the glove compartment ⇒ Chapter 70-1.
–
–
Disconnect airbag unit connector.
–
Unscrew bolts -2-.
–
Remove airbag unit -1- from the dash panel.
Installing
Note
secure using a securing screw -Loctite 275-.
–
Install airbag unit on dash panel holder.
Tightening torque: 10 Nm.
–
Connect the airbag unit connector.
Install glove compartment ⇒ Chapter 70-1.
–
–
Switch on ignition.
–
Connect earth cable of the battery.
Edition 10.03
S00.5319.13.20
Airbag
69
69-3
7
page