Fault Table Convenience System With Can Databus Cable - Skoda FABIA 2000 Workshop Manual

01
Fault table Convenience system with
CAN databus cable
Note
♦
Below is a list of all possible faults detected by the
central control unit for convenience system -J393- and
displayed on -V.A.G 1552 -, arranged according to
their 5-digit fault code.
♦
SAE code, may be displayed on the right next to the
fault number (e.g. 4214), ignore.
♦
If „Info in literature" appears in the display of the vehi-
cle system tester, look for the text required in the fault
table under the fault code.
♦
After repair always interrogate the fault memory using
vehicle system tester -V.A.G 1552- and erase the
memory.
♦
If parts are output as faulty: First check all cables and
connectors to these components as well as the earth
connections according to the Current Flow Diagram.
Then check whether all plug connections are properly
plugged into the relay plate. Replace the component
only if this test does not reveal any fault. This applies
in particular if faults are shown as „sporadic" (SP).
Display on V.A.G. 1552
65535
no fault detect-
ed
00849 undefined switch
S contact on ig- status
nition starter
switch D -D-
00912 Implausible signal
Switch for FL
window lifter
-E40-
00913 Implausible signal
Switch for FR
window lifter,
driver's side
-E81-
01-2
4
page
Possible cause of fault
If after repair „No fault detected" is displayed, the self-diagnosis is complet-
ed.
♦
Terminal 15 O.K., S contact de-
fective
♦
Cables or plug connections de-
fective
♦
Cables or plug connections de-
fective
♦
Switch for FL window lifter -E40-
defective at central switch
♦
Switch for FL window lifter -E40-
loose at central switch
♦
Cables or plug connections de-
fective
♦
Switch for FR window lifter -E81-
defective at central switch
♦
Switch for FR window lifter -E81-
loose at central switch
Self-diagnosis for convenience system with CAN databus cable
FABIA 2000
Rectifying fault
–
Reading measured value block
⇒ 01-2 page 16
–
Check wiring and plug connec-
tions according to the current flow
diagram
–
Check wiring and plug connec-
tions according to the current flow
diagram
–
Replace central switch for win-
dow lifter
–
Check switch FL fastening
–
Reading measured value block
⇒ 01-2 page 16
–
Check wiring and plug connec-
tions according to the current flow
diagram
–
Replace central switch for win-
dow lifter
–
Check switch FR fastening
–
Reading measured value block
⇒ 01-2 page 16
S00.5319.15.20
Body Work
Edition 01.05