01
Note
♦
One of the following four displays will appear in the
event of a communication set-up failure between ve-
hicle system tester -V.A.G 1552- and the control unit.
♦
Press
key to display the possible fault causes.
HELP
Readout on display:
Readout on display:
Readout on display:
Readout on display:
Note
♦
Possible fault causes in previous fault messages
could be:
♦
Malfunctions occurred at the start of or during the pro-
gram (external sources of interference).
♦
Interference in the wiring to the vehicle system tester,
malfunctions in the vehicle system tester or faults in
the vehicle communication wires.
♦
Serious faults in the relevant vehicle system, e.g. con-
trol unit destroyed.
♦
Inspect the connection of the vehicle system tester
-V.A.G 1552-, also check the communication cable
and the relevant vehicle system ⇒ Current Flow Dia-
grams, Electrical Fault Finding and Fitting Locations.
–
After removing the possible fault cause re-enter ad-
dress word 15 for „Airbag" and confirm entry with key
.
Q
Read-out on display after entering address word 15 „Air-
bag", e.g.:
→
–
Press
key.
Readout on display:
Overview of selectable functions
Operation
01 - Interrogating control unit ver-
sion
02 - Interrogating fault memory
03 - Actuator diagnosis
05 - Erasing fault memory
06 - End output
07 - Code control unit
08 - Read measured value block
10 - Adaptation
01-5
4
page
Page
⇒ 01-5 page 5
⇒ 01-5 page 6
⇒ 01-5 page 6
⇒ 01-5 page 7
⇒ 01-5 page 8
⇒ 01-5 page 8
⇒ Chapter 01-6
⇒ Chapter 01-7
Self-diagnosis for Airbag System I
Vehicle system test
The control unit does not respond
Vehicle system test
K cable does not connect to pos. term.
Vehicle system test
No signal from the control unit
Vehicle system test
Fault in communication set-up
6Q0909605 H
02 AIRBAG VW5
Coding 12338
Vehicle system test
Select function XX
FABIA 2000
Body Work
HELP
HELP
→
→
0003 →
WSC XXXXX
HELP
Edition 01.05
S00.5319.15.20