Yaesu FT3Dr Instruction Manual page 60

3 Touch [APRS].
4 Turn the DIAL to select [24 MY POSITION] and touch it on the display.
5 Turn the DIAL to select the memory to register.
Select a memory channel from P1 to P10, to register the position information.
6 Press the [DISP] key.
7 Touch [P.WRITE]. The position information is registered to the selected
memory channel.
In standard operation of APRS, the position of your station is automatically
acquired via GPS.
Other than when a GPS antenna unit is connected to your station, be sure to
have the setting as "GPS".
y 25 MY SYMBOL
Symbol setting for your station
Setting Item: Symbol
Default: 1: Human/Person (
2: Bicycle (
3: Car (
4: Yaesu Radios (
Explanation: Set the symbol for your station to transmit.
Select your symbol from 48 types.
y 26 POSITION COMMENT
Set up the position comment function.
Setting Item: Off Duty / En Route / In Service / Returning / Committed / Special / Priority/
Custom 0 / Custom 1 / Custom 2 / Custom 3 / Custom 4 / Custom 5 /
Custom 6 / Emergency!
Default: Off Duty
Explanation: Select the position comment (standard message) incorporated into
beacons of your station.
Unless there is a serious emergency, such as an accident or natural disaster,
do not select [EMERGENCY!].
y 27 SmartBeaconing
Settings for SmartBeaconing
Setting Item: STATUS:
LOW SPD:
HIGH SPD:
SLOW RATE: 1min to 100min
FAST RATE: 10sec to 180sec
TURN ANGL: 5° to 90°
TURN SLOP: 1 to 255
TURN TIME: 5sec to 180sec
)
)
)
)
OFF / TYPE1 / TYPE2 / TYPE3
2 to 30
6 to 90
59