Yaesu FT3Dr Instruction Manual page 31

1
Press and hold the [DISP] key → Touch [APRS] → [18 DIGI PATH].
2
Turn the DIAL to select the DIGI PATH.
Select the DIGI PATH from P1 - P8.
P1 (OFF) P2 (WIDE1-1), P3 (1:WIDE1-1/2:WIDE2-1) are
fixed values.
The relay method etc. can be entered for P4 - P8.
Proceed to Step 10 if you select P1 - P3, and Step 3 if
you select P4- P8.
3
Press the [DISP] key
Switch to the address selection screen.
Press the [BACK] key to return to the previous screen.
4
Turn the DIAL to select the address.
Select the address (1, 2).
8 addresses can be set for P8 only.
5
Press the [DISP] key.
6
Enter the call sign using the text input screens.
Refer to "Text input screen" (FT3DR/DE Operating Manual) on how to enter text.
7
Touch [ ].
8
Touch the SSID you want to set.
9
Press the [BACK] key.
The digipeater route will be set.
10
Press the PTT.
To exit the set mode and return to the operating screen.
30
18 DIGI PATH
P1 P2
P3 P4
P5 P6
P7 P8
18 DIGI PATH
P8(8):
Address1 -------
Address2 -------
Address3 -------
Address4 -------