Yaesu FT3Dr Instruction Manual page 57

ITEM: ON: ITEM BEACON information (BEACON displayed as [I] or [i] on LIST)
OFF: ITEM BEACON information is not output when set to OFF.
Tip
If you are to connect the transceiver with a PC using CT-169, the following settings must be applied
on the PC.
DATA SPEED: 9600bps (the SPEED setting of this transceiver and a PC must correspond).
DATA LENGTH: 8bit
Parity Bit: None
Stop Bit: 1bit
y 18 DIGI PATH
Setting the digipeater route.
Setting item: P1
P2:
P3:
P4 to P7: Up to 2 addresses can be entered arbitrarily.
P8:
Default: P3: FWIDE1-1 AWIDE2-1 (fixed value)
Explanation:
A station that relays packets, such as beacons, is called a digipeater.
Select a CALLSIGN or ALIAS of the digipeater you would like to use.
In this transceiver, [WIDE1-1] (setting for 1 relay station) and [WIDE1-1/WIDE2-1] (setting
for 2 relay stations) is the default.
In [WIDE1-1, WIDE2-1], a transmission is relayed to the first digipeater station specified
as WIDE1-1, then to the second digipeater station specified as WIDE2-1.
In the USA, digipeater stations used by APRS are customarily operated using *New-
Paradigm.
The initial values set to this transceiver are premised for digipeater stations operating with
New- Paradigm, because most digipeater stations support this method.
In order to use other relay methods, select one of P4 to P8 and enter the CALLSIGN or
ALIAS.
* For information on the New-Paradigm method, refer to the following website for details.
http://aprs.org/fix14439.html
is output with WAPOINT data.
OFF
WIDE1-1 (fixed value)
WIDE1-1, WIDE2-1 (fixed value)
Up to 8 addresses can be entered arbitrarily.
56