Figure 4-7 Ipv6 Filter - Zte ZXHN H268A Maintenance Management Manual

Parameter
Egress
3. Click Apply button to apply the changes.
l
Configure IPv6 filter.
1. Click IP Filter – IPv6 to open IP Filter – IPv6 page, see

Figure 4-7 IPv6 Filter

2. Configure the IPv6 filter parameters.
Table 4-5 Description of the IPv6 Filter Parameters
Parameter
IPv6 Filter Switch
Name
Mode
Protocol
SJ-20150916162339-007|2017-02-16 (R1.0)
Chapter 4 Configure the Internet
Description
Specify the data traffic direction. The ingress option and
egress option cannot be the same.
If the ingress is LAN, the egress should be a WAN con-
à
nection. The data traffic direction is upstream.
If the ingress is a WAN connection, the egress should be
à
the LAN. The data traffic direction is downstream.
Table 4-5 lists the IPv6 filter parameters.
Description
Select On to enable the IPv6 filter.
Select Off to disable the IPv6 filter.
Name of the IPv6 filter item.
The name must be specified.
Specify to discard or permit the data packages.
Protocol name, including TCP, UDP, TCP and UDP, ICMPv6,
Any.
Select the protocol that needs to filter packets.
By default, it is TCP.
4-13
ZTE Proprietary and Confidential
Figure 4-7.