Configure The Ethernet Connection; Qos; Configure The Qos Global Parameters; Configure The Qos Classification - Zte ZXHN H268A Maintenance Management Manual

ZXHN H268A Maintenance Management Manual(EXETEL)
Parameter
VLAN ID
– End of Steps –
Related Task
Select Internet > WAN > DSL > DSL Modulation Parameters. You can configure the
DSL modulation types and enhance capability.

4.1.3 Configure the Ethernet Connection

Ethernet configuration process refers to

4.2 QoS

4.2.1 Configure the QoS Global Parameters

The procedure provides the function of
configuration. Packets that match no classification rules will be processed according to
open the default policy showed in The procedure.
Steps
1. On the main page of the ZXHN H268A, select Internet > QoS > QoS Global
Configuration to open the QoS Global Configuration page, as shown in

Figure 4-3 QoS Global Configuration

2. Select Off to enable the QoS function. By default, this function is enabled. Then click
Apply button to apply the changes.
– End of Steps –

4.2.2 Configure the QoS Classification

The procedure provides the parameters of QoS classification configuration features.
SJ-20150916162339-007|2017-02-16 (R1.0)
Description
Identifies a VLAN. Range: 0 – 4094. To ensure normal service
operation, the VLAN ID must be the same as that set in
upper-layer configuration.
4.1.2 Configure the DSL
QoS switch and other global parameters
4-8
Connection.
ZTE Proprietary and Confidential
Figure 4-3.