Zte ZXHN H268A Maintenance Management Manual page 17

1. Click Create New Item to open the page of creating new DSL connection.
2. Enter the name of the WAN connection in Connection Name .
3. Set the DSL transfer mode to be ATM.
4. Configure the VPI/VCI.
The VPI/VCI provided by carriers must be set.
5. Set the Type to be Routing.
6. Set the Link Type to be IP.
7. Set the IP Version to be IPv4.
8. Set the IP Type to be DHCP.
9. Click Apply to apply the changes.
While
perform
required to get the best performance.
10. Check the configuration.
The IP address getting from carries can verify that the WAN Connection based
on IPv4 was completed successfully.
l
Static (IPv4) configuration process
1. Click Create New Item to open the page of creating new DSL connection.
2. Enter the name of the WAN connection in Connection Name .
3. Set the DSL transfer mode to be ATM.
4. Configure the VPI/VCI.
The VPI/VCI provided by carriers must be set.
5. Set the Type to be Routing.
6. Set the Link Type to be IP.
7. Set the IP Version to be IPv4.
8. Set the IP Type to be Static.
9. Configure the IPv4 relevant parameters, including IP Address, Subnet Mask,
Gateway and DNS1 . DNS2 and DNS3 are optional.
10. Click Apply to apply the changes.
While
perform
required to get the best performance.
11. Check the configuration.
While
perform
required to get the best performance.
l Bridge configuration process
1. Click Create New Item to open the page of creating new DSL connection.
2. Enter the name of the WAN connection in Connection Name .
3. Set the DSL transfer mode to be ATM.
4. Configure the VPI/VCI.
SJ-20150916162339-007|2017-02-16 (R1.0)
the default settings
well in most
the default settings
well in most
the default settings
well in most
4-3
Chapter 4 Configure the Internet
to remaining
cases, some reconfigurations
to remaining
cases, some reconfigurations
to remaining
cases, some reconfigurations
ZTE Proprietary and Confidential
parameters should
might be
parameters should
might be
parameters should
might be