Zte ZXHN H268A Maintenance Management Manual page 20

ZXHN H268A Maintenance Management Manual(EXETEL)
Parameter
MBS
Type
Service List
MTU
Link Type
PPP
PPP Transfer Type
Username
Password
IP Version
IPv4
IP Type
IP Address
Subnet Mask
SJ-20150916162339-007|2017-02-16 (R1.0)
Description
Maximum Burst Size, range = 1 – 20001
If Service Type is selected to be VBR-nrt or VBR-rt, MBS
needs to be configured.
The connection type includes Routing and Bridge
Connection.
In this case, Route is selected.
The default options: INTERNET_VOIP_TR069.
This parameter must be consistent with service configuration.
For example, if INTERNET_VoIP_TR069 is selected, it
indicates that the WAN connection supports the Internet access
service , remote management and the voice service.
If Link Type is set to be IP, MTU range is 576 – 1500, default:
1500. If Link Type is set to be PPP,
MTU range is 128 –1492.
Default: 1492.
There are two link types: PPP and IP.
There are two PPP transfer types: PPPoE. PPPoA. The default
value is PPPoE.
Username of the PPPoE account. The username must be the
same as that set on the peer server for authentication.
Password of the PPPoE account. The password must be the
same as that set on the peer server for authentication.
IP version that the device supports. Normally, it is set to be
IPv4.
l IPv4: The device supports
l
IPv6: The device supports
l
IPv4/IPv6: The device supports both
addresses.
Options:
l DHCP: The DHCP server automatically allocates a
dynamic IP address to open the device.
l
Static: You need to specify a static IP address for the
device.
We need to specify the IPv4 address for the WAN connection
when IP Type is Static.
We need to specify the subnet mask of the WAN connection
when IP Type is Static.
4-6
IPv4 addresses only.
IPv6 addresses only.
IPv4 and
ZTE Proprietary and Confidential
IPv6