Configure The Dsl Connection - Zte ZXHN H268A Maintenance Management Manual

ZXHN H268A Maintenance Management Manual(EXETEL)
To
Display the DSL link information
and DSL connection status
Display the Ethernet interface
information and connection status
2. Click Refresh to refresh the information.
– End of Steps –

4.1.2 Configure the DSL Connection

This procedure describes how to configure a broadband connection (WAN connection) on
the network side, so that the subscribers can access the external network.
The ZXHN H268A device supports two xDSL transfer modes: ATM and PTM.
This procedure takes ATM for example, and configure the four modes of using this
transfer mode.
PTM transfer
configuration process.
Configuration Process
l
PPPoE (IPv4) configuration process
1. Click Create New Item to open the page of creating new DSL connection.
2. Enter the name of the WAN connection in Connection Name .
3. Set the DSL transfer mode to be ATM.
4. Configure the VPI/VCI.
The VPI/VCI provided by carriers must be set.
5. Set the Type to be Routing.
6. Set the Link Type to be PPP.
7. Set the PPPoE Transfer Type to be PPPoE.
8. Configure the Username and Password.
The username and password are provided by carriers.
9. Set the IP Version to be IPv4.
10. Click Apply to apply the changes.
While
perform
required to get the best performance according to open the carriers.
11. Check the configuration.
The IP address getting from carries can verify that the WAN Connection based
on IPv4 was completed successfully.
l
DHCP (IPv4) configuration process
SJ-20150916162339-007|2017-02-16 (R1.0)
Do this
Select Internet > Status > DSL.
Select Internet > Status > Ethernet.
mode configuration
the default settings
well in most
4-2
process refers
to remaining
cases, some reconfigurations
ZTE Proprietary and Confidential
to ATM transfer
parameters should
might
DSL
mode
be