Configuring 4In6 Tunnel Connection - Zte ZXHN H168N Maintenance Management Manual

Parameter
PDP Type
APN
Dial Number
MTU
Username/Password
Authentication Type
Connection Mode
Auto-disconnected without traffic
NAT
5. Click Apply.
– End of Steps –

5.2.3 Configuring 4in6 Tunnel Connection

This page provides the parameters of 4in6 Tunnel configuration features.
Steps
1. On the main page of the ZXHN H168N, select Internet > WAN > 4in6 Tunnel to go to
the 4in6 Tunnel page, as shown in
SJ-20140220172310-002|2014-03-03 (R1.0)
Switch
Description
There are two PDP types:
l
IP
l
PPP
Access Point Name.
Set the communication standard of the access network to
be used.
Dial Number.
Different communication standards have different dial
numbers.
Define the maximum transfer unit.
The Username/Password of new
There are three authentication types:
l Auto
l
PAP
l
CHAP
There are two connection modes:
l
Always On
l
On Demand
Setting this parameter when Connection Mode is On
Demand.
Select on/off NAT switch function.
Figure 5-15.
5-13
ZTE Proprietary and Confidential
Chapter 5 Internet
3G connection.