Table of Contents
Advertisement
Operator programmable features are identified by a Point Number and Parameter
Number. The Point Number refers to the Transducer (clarifier) Number, Relay
Number, or mA Output Number as identified by the Point Type indicators.
Parameter Numbers have a preset Parameter Value for each Point Number.
Programming is accomplished by altering the preset Parameter Values as
required to obtain the RUN mode operation desired. All operator programmable
features are defined in the Quick Start Parameters, Application Parameters, and
Enhancement Parameters sections of this instruction manual.
Display
In the program mode, the Point Type, Point Number, Parameter Number, and
Parameter Value (as well as a variety of other programming information) may be
viewed.
Note that many indicators are specific to certain programming conditions and
therefore, not all indicators are displayed at any given time.
transducer
relay
analog output
TS-3
index
Parameter Number the programmable feature the Parameter Value pertains to.
Point Type
Point Number
Parameter Value
Percent
Invalid Entry
Auxiliary Function
Scroll Access Tag
Program Mode
InterRanger DPS300
point
number
point
type
relay in
program
service
mode
the Point Number refers to a Transducer, Relay, mA Output, or
TS-3.
the Transducer, Relay, mA Output or TS-3 # the Parameter
Value pertains to.
the current value of the Parameter Number for the Point
Number displayed.
indicates the Parameter Value is displayed in percent.
indicates the value entered is questionable (are you sure?).
indicates Auxiliary Function access (applies to only some
Parameter Numbers).
indicates the Parameter Value may be scroll accessed.
indicates the program mode is accessed.
42
PROGRAMMING
parameter
units
value
invalid
parameter
entry
number
7ML19981BC01
auxiliary
function
scroll
access tag
Advertisement
Table of Contents
