Enhancement Parameters; Data Logging Parameters (P300 And P302) - Siemens interranger DPS300 Instructional Manual

This section identifies all DPS300 operator programmable features designed for
altering operation to suit individual operator preferences or overcome
measurement difficulties.
Typically, these parameters are only altered as directed by the
TROUBLESHOOTING GUIDE. If RUN mode performance requires improvement,
access and alter the following parameters as required.
Note:
Otherwise, proceed to OPERATION.
PARAMETER CATEGORY
Data Logging
Profile Records
Installation Records
Range Calibration
Temperature Compensation
Rate
Measurement Verification
Display Parameters
Echo Processing
Advanced Echo Processing
Test Parameters
Measurement Parameters
Master Reset
Note:
When an Enhancement Parameter is altered, return to the RUN mode to verify the
performance desired is achieved, before making any other changes.

Data Logging Parameters (P300 and P302)

View the maximum Temperature recorded in the RUN mode.
P300 (V) Temperature, Transducer Max
Use this feature to view the highest temperature recorded (in ° C) by the XCT-12
transducer.
Values:
P302 (V) Temperature, Sensor Max
Use this feature to view the highest temperature recorded (in ° C) by the TS-3
temperature sensor, if used.
When accessed, the TS-3 symbol is displayed in the Point Type field and the TS-3
Number is displayed in the Point Number field.
Values:
InterRanger DPS300

ENHANCEMENT PARAMETERS

PURPOSE
to view previous maximum Temperature records
intended for use by Siemens Service Personnel
to identify length of service and power failure occurrence
to compensate for measurement offset and/or sound velocity
to override automatic temperature compensation features
to adjust the rate of response to change in the sludge level
to adjust the rate of response to change in the sludge level
to override the preset display operating characteristics
to troubleshoot false echo detection
intended for use by Siemens Service personnel
intended for use by Siemens Service personnel
to verify Application Parameter programming
to reset Parameter Values to factory settings
-50 to 150
-50 to 150
68
PAGE
68
69
72
72
74
75
77
78
81
83
90
92
93
7ML19981BC01