Manually Update Software; Automatically Update Software; Update Software With A Usb Flash Drive - Polycom Pano Administrator's Manual

Related Links
Provisioning Service on page 17
Related Links
Register with Polycom Cloud Service

Manually Update Software

You can manually update the system software.
Procedure
1. In the system web interface, go to General Settings > Software Update.
2. Select Check for Updates.
3. If updates are found, select Update.

Automatically Update Software

You can automatically update the Pano system software.
Note: Automatic software updates are enabled by default when your system is registered to the
Polycom Cloud Service.
Procedure
1. In the system web interface, go to General Settings > Software Update.
2. Select Enable Automatic Updates.
Unless you specify a maintenance window, your system tries to update a minute after you enable
this setting. If an update isn't available at the time, the system tries again every four hours.
3. Optional: Select Only Check for Updates During Maintenance Hours to specify a range of time
to automatically update the software.
4. Optional: Choose times for Maintenance Hours Begin and Maintenance Hours End.
The system calculates a random time within the defined maintenance window to check for
updates.
Note: If these settings are provisioned, the provisioning profile defines the polling interval. The
default interval is one hour.
Your changes save automatically.

Update Software with a USB Flash Drive

You can update the software of your Pano system and some of its connected devices with a USB flash
drive.
Note: Polycom recommends formatting your USB flash drive with the FAT32 file system.
Procedure
1. Get the software package you want to install from
2. Save the package to the root directory of a USB flash drive and unzip the file.
Polycom, Inc.
on page 16
Polycom
System Maintenance
Support.
45