Configure Dns Settings; Configure Lan Options - Polycom Pano Administrator's Manual

Setting
4. Select Save.

Configure DNS Settings

You can manually configure the DNS server settings for your system.
DNS settings apply to both the Primary network (LAN) and Secondary network (Wi-Fi).
Procedure
1. In the system web interface, go to Network > Primary Network.
2. In the system web interface, go to Network > DNS.
3. If the system does not automatically obtain a DNS server address, enter one on this page (up to
four are allowed).
4. Select Save.

Configure LAN Options

There are several options for configuring the LAN in your Pano system web interface.
Procedure
1. In the system web interface, go to Network > Primary Network.
2. Under the LAN Options section, configure the following settings as needed:
Setting
Host Name
Domain Name
Autonegotiation
LAN Speed
Polycom, Inc.
Description
If your system doesn't automatically obtain a
gateway IP address, enter one here.
Description
Indicates the system name
The domain name assigned to the system.
If the system does not automatically obtain a
domain name, enter one here.
Specifies whether the system should
automatically negotiate the LAN Speed and
Duplex Mode per IEEE 802.3 autonegotiation
procedures. If enabled, those settings become
read-only.
Polycom recommends that you use
autonegotiation to avoid network issues.
Specifies whether to use 10 Mbps, 100 Mbps,
or 1000 Mbps for the LAN speed. The duplex
mode you choose must be supported by the
switch.
Network Settings
21