Polycom Pano Administrator's Manual page 25

Note: Note the following:
▪ When you select a non-default operating channel for Miracast, the secondary network is
disabled to avoid frequency conflict with Miracast connections. If you don't use the
secondary network, you can select a non-default operating channel which works best in
your Wi-Fi environment.
▪ When you enable the secondary network, the Miracast Operating Channel option is
disabled to ensure Miracast and the secondary network use the same channel. However, if
the secondary network is connected to a Wi-Fi Access Point (AP) working on a Dynamic
Frequency Selection (DFS) channel, Miracast may not work properly. This is because some
Wi-Fi drivers don't support DFS channels well.
Procedure
1. In the system web interface, go to Network > Secondary Network.
2. In the system web interface, go to Network > Wi-Fi Network.
3. For Choose Network Type, select Wi-Fi.
4. Select Enable Administrator Access to This Network to enable administrators to access the
system web interface on the Wi-Fi network.
For higher security, you can disable this option to limit access to the system web interface through
LAN connections only.
5. Do one of the following:
▪ Select a network from Available Wi-Fi Networks. (The system lists networks in order of
signal strength.)
▪ Enter the network name in the SSID field.
Selecting a new SSID erases the previous SSID and relevant Wi-Fi settings from the system.
6. Configure the following settings:
Available settings vary with your selections.
Setting
Security
Key (Passphrase/PSK)
EAP Method
Polycom, Inc.
Description
Specifies the encryption protocol:
▪ None
▪ WEP
▪ WPA/WPA2-PSK
▪ 802.1xEAP
Specifies an encryption passphrase (like a password) for the Wi-Fi network. You
must enter the passphrase to connect to the Wi-Fi network.
Specifies the extensible authentication protocol (EAP) for WPA-Enterprise
(802.1xEAP):
▪ PEAP
▪ TLS
▪ TTLS
▪ PWD
Network Settings
23