Set Up System Manually; Provision The System - Polycom Pano Administrator's Manual

Hide thumbs Also See for Pano:

Table of Contents

If you forget your administrator password, you must reset the system and run the setup wizard

again to reset the password.

3. Optional: Select the Change username checkbox to create a new username.

The default username is admin.

Set Up System Manually

You can finish setting up your system manually after you change your default password.

Procedure

1. On the welcome screen, select Manual Setup.

2. Select a language for the system.

3. Select the country where the system is located.

4. Do one of the following on the Polycom Cloud Service registration page:

▪

Select Sign In to register your system with the Polycom Cloud Service.

▪

Select Skip to set up a standalone system.

5. If you chose Sign In, complete the Polycom Cloud Service registration.

6. Select Finish when prompted.

You can register your system with a provisioning service after you change your default password.

Procedure

1. On the welcome screen, select Provision.

The system searches for a provisioning service.

2. Complete the required fields for registering with the provisioning service and select Register.

If your system detects a provisioning service on the network, all the fields except Username and

Password are automatically completed. If a service is not detected, you must enter all the fields

manually.

3. If the Polycom Cloud Service registration page displays, select Sign In to register your system or

Skip.

You see this page only if your provisioning service allows your system to also register with the

Polycom Cloud Service.

4. Select Finish when prompted.