Set Device And Room Names; Register With Polycom Cloud Service - Polycom Pano Administrator's Manual

Hide thumbs Also See for Pano:

Table of Contents

Set Device and Room Names

You can set the device and room names associated with a standalone Pano system using the system

web interface.

You must use the Polycom Cloud Service Administration portal to change the names of a system that is

registered with the Polycom Cloud Service.

Procedure

1. In the system web interface, go to General Settings > Device and Room Name.

2. Enter the Device Name, Room Name, or both and select Save.

You can register your system to the Polycom Cloud Service through the setup wizard or in the system

web interface.

Besides the first step, the following instructions are the same whether you chose to register during initial

setup or later in the system web interface.

Procedure

1. In the system web interface, go to General Settings > Cloud. (Skip this step if you are running

the setup wizard.)

2. Select Sign In.

3. Enter your Email ID and Password.

The Email ID was activated through the Polycom Cloud Service Administration portal and enables

the system to locate your account.

4. Enter a Room Name.

A Room Name is how users identify a Pano system they want to connect to from a device or the

Content App. Polycom recommends that you use a name that is associated with the system's

location (e.g., a conference room).

5. Optional: Deselect the Enable Security Code checkbox if you do not want users to enter a code

to connect their device to the Pano system.

6. Keep the automatically generated Device Name or enter a new one.

This name identifies the Pano device in the Polycom Cloud Service portal dashboard.

7. Select Finish when prompted.