Polycom Pano Administrator's Manual page 26

Setting
Phase 2 Authentication
Username
Password
IP Address
Your IP Address Is
Subnet Mask
Default Gateway
DNS Server
DNS Alternate Server
When you connect, you receive a Successfully connected to <your network's SSID name>
message.
Related Links
Access the System Web Interface
Select the Miracast Operating Channel
Enable DFS on page 24
Enable DFS
You can enable Dynamic Frequency Selection (DFS) for Miracast and the secondary network on Pano.
Some Miracast-certified devices may not work as expected when connected to a DFS channel. In such
cases, disable the Allow DFS Channels option. This forces the secondary network to select an available
non-DFS channel to avoid signal interference.
DFS is disabled by default.
Procedure
1. Select Network > Secondary Network.
Polycom, Inc.
Description
Specifies the Phase 2 authentication method:
▪ MSCHAPV2
▪ GTC
Specifies the login user name for WPA-Enterprise (802.1xEAP).
Specifies the login password for WPA-Enterprise (802.1xEAP).
Select one of the following to set your system Wi-Fi network IP address:
▪ Obtain IP address automatically (You must have a DHCP server in your
environment to use this option.)
▪ Enter IP address manually
Specifies the IP address for the Wi-Fi network.
This setting is read-only if your system gets its IP address automatically.
Specifies the subnet mask address for the Wi-Fi network.
This setting is read-only if your system gets its IP address automatically.
Specifies the IP gateway for the Wi-Fi network.
This setting is read-only if your system gets its IP address automatically.
Specifics the DNS server address for the Wi-Fi network.
This setting is read-only if your system gets its IP address automatically.
Specifics the alternate DNS server address for the Wi-Fi network.
This setting is read-only if your system gets its IP address automatically.
on page 8
on page 36
Network Settings
24