Delete A Certificate; Change Local Account Credentials; Disable The Security Code - Polycom Pano Administrator's Manual

Delete a Certificate

You can remove user-installed certificates through the Pano system web interface.
When you delete all user-installed certificates, your system reverts to using the factory-installed
certificate. This option isn't available if your certificate is provisioned to the system.
Note: Deleting system settings by default retains your user-installed certificates, but performing a
factory reset removes these certificates.
Procedure
1. In the system web interface, go to Security > Certificates.
2. Locate the certificate you want to delete and select Delete
You can't undo this action.
3. Confirm by selecting Delete.
A message indicates that the system deleted the certificate.

Change Local Account Credentials

The Pano system administrator ID and password you created while running the setup wizard can be
changed.
Procedure
1. In the system web interface, go to Security > Local Accounts.
2. Change your credentials (username or password) and select Save.

Disable the Security Code

By default, you must enter a security code to connect to the system to share or save content, but you can
disable it.
Procedure
» Disable the security code in one of the following ways, depending on your setup:
▪ In the system web interface, go to Security > Security Code and clear the Enable Security
Code check box. This setting is read-only if your system is registered to the Polycom Cloud
Service.
▪ Edit the system settings in the Polycom Cloud Service Administration portal.
▪ Update the system's provisioning profile in RealPresence Resource Manager.
Related Links
Enforce Security Code for Every Connections
Polycom, Inc.
in the same row as the certificate.
on page 37
Security
34