Setup Group Parameters - YASKAWA FSDrive-MV1000 Series Instructions For Use Manual

u Setup Group Parameters
Setup Group (SETUP)
n
Only the frequently used parameters are selected into the setup mode to simplify drive setup. Take the following steps to
modify parameters in the Setup Group:
1.
Press or
2.
Select a parameter, and change the setting.
Group. Use the "Parameter Setting Mode" screen to access parameters not found in the Setup Group.
Note: Changing parameter A1-02 will automatically change values of other parameters.
No.
A1-02 Control Method Selection
A1-06 Application Preset
b1-01 Frequency Reference Selection 1
b1-02 Run Command Selection 1
b1-03 Stopping Method Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
d1-01 Frequency Reference 1
d1-02 Frequency Reference 2
d1-03 Frequency Reference 3
d1-04 Frequency Reference 4
d1-17 Jog Frequency Reference
E1-01 Input Voltage Setting
E1-04 Maximum Output Frequency
Note: Parameter availability depends on the control mode set in A1-02; some parameters listed above may not be accessible in all
control modes.
YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions
until the "Setup Group" screen is displayed.
Table 4.5
Table 4.5 Setup Group Parameters
Name
4.3 The Drive and Programming Modes
shows the parameters that can be used in the Setup
No.
E1-05 Maximum Voltage
E1-06 Base Frequency
E1-09 Minimum Output Frequency
E1-13 Base Voltage
E2-01 Motor Rated Current
E2-04 Number of Motor Poles
E2-11 Motor Rated Power
H4-02 Analog Output 1 Gain
H4-12 Analog Output 2 Gain
H4-22 Analog Output 3 Gain
H4-32 Analog Output 4 Gain
L1-01 Motor Overload Protection Selection
L3-04 Stall Prevention Selection during Deceleration
Name
4
119