Switching Between Local And Remote - YASKAWA FSDrive-MV1000 Series Instructions For Use Manual

4.3 The Drive and Programming Modes
u Switching between LOCAL and REMOTE
LOCAL mode is when the drive is set to accept the Run command from the digital operator RUN key. REMOTE mode is
when the drive set to accept the Run command from an external device (i.e., input terminals, communication option, or
other any devices) this is referred to as REMOTE mode.
WARNING! Sudden Movement Hazard. The drive may start unexpectedly if the Run command is already applied when switching
from LOCAL mode to REMOTE mode when b1-07 = 1, resulting in serious injury or death. Be sure all personnel are
clear of rotating machinery.
Switch the operation between LOCAL and REMOTE using the
Note: 1. After selecting LOCAL, the LO/RE light will remain lit.
2. The drive will not allow the user to switch between LOCAL and REMOTE during run.
Using the LO/RE Key on the Digital Operator
n
1 Energize the drive control power. The initial display will appear.
Press . The LO/RE light will light up. The drive is now in LOCAL.
2
To set the drive for REMOTE operation, press the
on.
Using Contact Input Terminals 1 to 16 to Switch between
n
It is possible to switch between LOCAL and REMOTE modes using one of the contact input terminals H1-01 to H1-16
(set the corresponding parameter H1-
Note: Setting H1- to 1 disables the LO/RE key on the digital operator.
118
Operating Procedure
key again. The LO/RE light will turn
LO
RE
to 1).
key on the digital operator or via a digital input.
LOCAL and REMOTE
YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions
LCD Display